View Single Post
  #7  
Old 07-19-2010, 09:41 PM
metalstudman1's Avatar
metalstudman1 metalstudman1 is offline
Super Moderator
 

Join Date: Aug 2009
Location: Belmont,NC (elevation 534')
Posts: 2,668
Default

Look at the attachments, remove the spring end that's on your governor arm. Bend a piece of wire (welding rod works well, even an old coat hanger!)Throttle works left to right.Idle stop left- full throttle turned to the right.This linkage is usually put on while installing the carb. You rotate the carb to get the opposing bends in their slots.If the bends are the same direction it fall out during throttling.
Does this help?
Attached Images
File Type: jpg tecumseh carb 1.jpg (90.0 KB, 25 views)
File Type: jpg tecumseh carb 2.jpg (93.4 KB, 25 views)
Reply With Quote