[BEEFKING69]

So i picked up a GS Moon buggy 150 a year or so ago for 100 bucks with good seats and 4 like new tires and its been the the biggest pile of junk ive ever had but also the coolest pile of junk and i cant bring myself to sell it cause its so unique and the only one ive ever seen and the only 150cc ive ever seen with IRS from the factory.

The main issues being its direct drive with an open differential and its geared way to high and reverse is geared higher than forward :roll: It also has very little ground clearance ontop of being one wheel peel. So on the ground clearance note i added longer shocks and then on the first ride it pulled both inner joints apart #-o So hopefully i can fix that without to much fuss.

Some ideas ive been tossing around is to weld the spider gears to lock the rearend as its really not trail friendly as is but is still geared to high although i did put 12g sliders in it and that helped some. Ive also been thinking about how to convert it to chain drive using a HH250ss center section and cv axles. If i go through that process it would also get a 250cc or bigger motor on it. I would most likely have to cut and sleeve the HH250 axles and the factory axles together to get the right length.

It would be nice if i could find some gears to swap the factory ones with but thats unlikely. I may just start off with welding the spider gears and adjust the shocks down just a hair and put limiting straps on each trailing arm to prevent then from pulling apart again. I want to keep it and keep it usable but the low ground clearance and open diff are just show stoppers for where we ride.