Just like any other switch the trigger either works or doesn't. You can repair that broken wire by stripping both ends sliding some shrink tubing over one end then soldering the wire together. Make sure the trigger wire is disconnected from the harness and using an alligator clip as a heat sink just prior to trigger itself heat the joined wires just enough so that when you touch the solder to wire it melts and sucks itself all through the wire. You should only use a pencil type iron since it is a lower wattage than the gun type. You will also need the super thin solder about the diameter of a stick pin. You want to keep the heat to a minimum so just to melt the very thin solder.
|