hey Ckau, I have a spare spiderbox swing arm that I'm gonna build up for my new axle. I saw on your other buggy that you had built the extra bearing supports closer to the hubs, and you still had the stock ones in place along with the center one for extra support for the sprocket.
I was thinking If I just cut off the stock hangers and built the frame a little wider in that area closer to the hubs (like you did), would I still need the bearings in the stock places or could I just get away with the Three... One in the center, and two on the outside?
I like the dual break Idea in the back also, nice. I think it would be in the way of the muffler with a stock setup or would you just bend the pipe different?
__________________
T.J.
Yerfdog Spiderbox, Uni Type air filter with 6" intake, 130 jet, Orange no-rev limit cdi, Red coil, iridium plug, 1500rpm clutch springs, 1500rpm contra spring, 13g sliders, 22" rears, 21" fronts, aftermarket reverse installed, and Trailtech Vapor.
|