American Sportworks 7150 Carbide will not fire
I have an American Sportworks 7150 Carbide that will turn over and not fire. It was running fine last year then all of a sudden while it was running it quit running. It would turn over but not fire. I replaced the coil/spark plug wire and plug and still nothing. I found the wiring harness a little messy so my brother and I tried cleaning it up and still nothing.
I bought a new CDI(it is a little smaller than the orginal one) - still will not fire. I just replaced the stator, put a new ignition coil/spark plug wire, spark plug and replaced the wiring harness that is at the engine. I am still not getting anything. I have pulled the plug out and tried grounding it to see if I can get a spark still nothing. Last night, my neighbor was holding the spark plug while it was inside the boot(he was sitting on the ground) when I plugged in the CDI, it would give him a small shock. Is there a ground that could be bad even with replacing the entire wiring harness in the back?
Any help would be greatly appreciated.
Clyde
|