The CDI you purchased sounds like an AC volt. The 7150 uses a DC volt CDI. I do have them in stock. Before you go any further you should check both kill switches. One is located on the electrical box that houses the CDI the other is on the dash. First make sure they are not made, than check with your ohm meter, they should be open for the engine to run. Also check to make sure your ignition switch is good. Both switches are known to go bad. The CDI you bought will not work so if your switches check good than you will need the correct CDI. You can go to American Landmaster and download the service manual for the 7150 where it will give you all the specs and instructions on how to troubleshoot the ignition system.
|