got back from the cruise and it was paint time. my father in law did all the prep work and paint while i was busy with customers most of that time.
christmas eve i started assembly and basically finished at the track and fired it up on the trailer. ran into a couple of hicups along the way. chain alignment was tough until we found the output shaft was bent. replacing it made life easier. the brake pedal was bending and binding up the return so i cut and moved that at the track.needless to say we got it loaded and i bolted the panels and the roof up in the trailer . all said and done the chassis feels great , in the little time i sat in it, but i still have an issue which i believe is the motor getting hot. i blame the seat and panels blocking the air to cool the motor. after 3 laps the motor starts to lose power. i have some ideas to help cure this so when i get a chance , i'll need to remedy this and make a shifter bracket so i can hook up the reverse.
__________________
"LUCIFER" JOYNER JD400,
CROSSHAMMER 250R,
YERF GX150,
CROSSFIRE MBX150,
BMS 800V-TWIN
'16 RZR 900s ,
'17 ACE 900XC,
'99KX250,
'94 KDX200,
'18 SSR SR170TX
|