Made a little head way this afternoon on the project. I finished up the steering, mounted the shifter, finished welding the roll bar & added some inner supports for the toppers. I just need to make a the inner harness mounting points and the roll bar should be ready to prep for paint. I ended up raising the shifter above the seats. It was just too darn tight with it mounted down lower. If I would have had another 1/2 an inch I could have made it work but it was rubbing when you shifted it and that's just no good.
The rear wheel spacers were delivered today, but I didn't get a chance to try them yet. I may hold off on them until I have ridden it first to see how it handles before adding them.
|