I was looking into hacking the cheesy 5/8" bolt/stud from the front spindles on my spiderbox, and maybe looking into trailer hubs for easy replacement and lubrication, but then there is the question of what would the inner seal ride on to seal properly? Then I found these.
http://www.*************.com/item.as...catname=wheels
Tell me what you guys think, I have the 3rd gen spindles so drilling a BA hole through both sides of the boxed section is not much of an issue. Being able to weld it flush on the inside also remedies the clearance issue I was anticipating when looking to go to 3/4" or 1" with the massive bolt head poking through.