Quote:
Originally Posted by metalstudman1
Got a lttle more done with the drive system. Shortened the the drive shaft, it has a small wobble (.015 out-of-round) It may or may not work!!!
So does anyone see any obvious issues?
|
Is the wobble as measured on the outside of the end of the shaft? It may just be a variation of the outer surface. If you do verify that it is caused by the shaft being off center, you could possibly integrate a rubber donut coupler at the connection to absorb any potential vibrations.
All looks good, just wondering what kind of chain length you're going to end up with if the axles end up setback as far as they're sitting on the floor.