you could, but it would just fall again. keep in mind, when you are running off your pilot jet at idle, the needle is SUPPOSED to be there, its when u put ur foot on the gas that it lifts up letting in more gas and air. when that little hole is clogged, it tells your motor to try to run off your pilot jet, which takes you right back to idle. when it happend to me, i could hit the gas and get to a slow roll, but if i touched the pedal more than about a half an inch, it would just go back to idle. i didnt explain it well, ill try again.
1. unscrew four screws on top of carb.
2. locate the large black rubber bladder.
3. pull it out.
4. pull the needle out of the bladder through the bottom of the bladder.
5. pull the "center" out of the bladder. (idk what to call it)
6. there should be a small metal disc inside with a hole in it.
7. put disc on needle while it is unnatched to anything, in youre hand or whatever. make sure disc is secured on the ring that is machined into the top of the needle.
8. soder it in place.
put needle down through top of bladder down through the bottom where it will stay suspended because u have reattached the disc.
9. put the "center" so to speak back into the bladder.
10. put bladder back in carb and put back in the four screws. you should be ready to go!
|