Ok got it to open. Looking at the schematic, the only things the switch is wired to are the start solenois, CDI, and kill switch.Basically it is a hot switch with an open ground so when you turn the key to the run position it completes the ground allowing current to flow to the CDI. The same applies to the to the start circuit. Have you checked the kill switch? The relay is for the flashers and will not affect the start or run . The diod should not affect the start circuit but if bad you will not get power to the ignition circuit. Check the green wire at switch it should go to ground, if not check that wire or for a bad ground. Also check the kill switch but even if the kill switch is bad it should still turn the starter for it will only affect the ignition.
|