Axle overall is right around 42 1/4" long. Sprocket is off center at 20 1/4" -- 22" measured at the center of the teeth.
The studs can be knocked out and flipped so the sprocket can be put on the other side of the hub --there is a clean land of the same diameter so it would still be hub-centric. That would move the sprocket to 19 1/2" -- 22 3/4".
Ckau -- hubs are 4 x 137. I have the rear rims on the rockhound.
If anyone wants the hub bearing land location measurements, lmk.
If i had this in hand, i never would have gone with the golf cart axle setup. I think i got it about 2 weeks after i made the golf cart swingarm.
|