Quote:
Originally Posted by x-bird
a cross brace on the rear is on the list, held off doing it until i know what i'm stuffing back there. my one concern is for those putting that in with a bearing mount on it or a bar from the underside---a good hit on the bar the bearing mount is on could end up bending the axle upwards.
|
I'm putting a bearing mount, but I doubt that it will take any hits... it will be only 5 or 6" from the left of the sprocket... it shouldn't hang down to low, I have about 8" of clearance from the bottom of my sprocket (39T)to the ground. With the bearing I'm sure it will be at least 10" of clearance.
__________________
T.J.
Yerfdog Spiderbox, Uni Type air filter with 6" intake, 130 jet, Orange no-rev limit cdi, Red coil, iridium plug, 1500rpm clutch springs, 1500rpm contra spring, 13g sliders, 22" rears, 21" fronts, aftermarket reverse installed, and Trailtech Vapor.
|