View Single Post
  #13  
Old 09-27-2017, 09:35 AM
tkeagle tkeagle is offline
Heavy Contributor
 

Join Date: Mar 2015
Location: Central Kansas
Posts: 556
Default

Some pics how mounted 5points. The front and 2 back straps, drilled and put bolts on the round tubing going under seat. Of course will need to remove seats to do so. For center ones, already a hole there. Just put long enough bolt to mount on each side. And outer ones, just use seat mount bracket bolt. At least is how I did it.

I did purchase the front lift kit upgrade from BD. To me, was money well spent. The shocks, not best, but very good upgrade. You can put a pre-load on them also.
I just had to buy new set of tie rod ends from them. Good upgrade as well.

Other pic is upgrade I did on bulkhead. 1/4 in plates in front and back of tabs that hold the A arms. Will need longer bolts. Think I got 8 inch grade 8 with nylon nuts off amazon. Don't need 8 inches. Think 7.5 will do. But with 8. Almost all threads are outside the pinch points.

If you are going this far. Look at BD, upgraded spindles, and ball joints. They have life time warranty. And they back there stuff up. If tight on money, would highly suggest the spindles first. They upgraded them lately. They good product.
Attached Images
File Type: jpg 20170926_111351.jpg (95.7 KB, 37 views)
File Type: jpg 20170926_111252.jpg (98.8 KB, 31 views)
File Type: jpg 20170803_101644.jpg (98.5 KB, 33 views)
File Type: jpg 20170901_164828.jpg (93.7 KB, 34 views)

Last edited by tkeagle; 09-27-2017 at 10:00 AM.
Reply With Quote