View Single Post
  #30  
Old 10-03-2017, 10:15 AM
Pripyat Pripyat is offline
Contributor
 

Join Date: Aug 2017
Posts: 143
Default

I won't have access to the kart for a couple days or I would have just gone and measured the ID and pitch of the existing tie rod. To reiterate, the existing (stock) tie rod is not 7/16-20. Or is it?

This kart project is getting alot more in depth than I was originally expecting. But I'm enjoying it. My son is 4 now so if I do everything right it will definitely pay off down the road.

[edit]
Ckau - I may have found the source of my confusion -

You said you have 1/2" tubing with 7/16" ID. Did you mean 3/4" tubing? I don't see any way to get a 3/8" bung on 1/2" tubing unless you butt-welded it.

Last edited by Pripyat; 10-03-2017 at 11:34 AM.
Reply With Quote