View Single Post
  #24  
Old 09-04-2015, 10:44 AM
SYCARMS's Avatar
SYCARMS SYCARMS is offline
Supporting Vendor
 

Join Date: Sep 2009
Location: Senatobia, Mississippi
Posts: 3,375
Default

Quote:
Originally Posted by ckau View Post
Those components really can't take a whole lot of pounding. That's why I mounted the box inside the frame. Still gets shook up a good bit but not near as rough as on the swing arm. I used the original mounting rack off the swing arm . it had the cutouts and rubber mounts for the electrical stuff. Cut it off the swing arm and after a little trimming and reshaping mounted it inside a water tight box. It's tight inside that box but the original yerf electric rack is in there.
I have to disagree with you on this one. I work on these buggies as a living and have seen no proof to this. Solenoids and CDI's are one of the least components I have to change out and most if not all 150 buggies have them mounted on the swing arm. As Xlint 89 stated a bad ground is your biggest enemy.
Reply With Quote