[300cpilot]

Really big picture post here. The shop that did the work is at www.getsomefab.com I think they did a great job! I spoke to the Yamaha shop and this motor was never offered with an electric starter, so we have to go back to the fab to put the pull starter back on. One of the supports is in the way.

Carb mock up, yes that is a copper elbo. I can not find a steel elbo that is that tight and 2" id. Leads on one would be nice.



Just getting an idea of what to do with the exhaust. This is the exhaust out of the sled, it is not what is going to end up on it, I hope. It almost works.




Mounts:















The only piece that still needs changed is the A-arm support above the cooling fan on the motor. We did not catch it at the fab shop. With it gone the stock rack will go right back on without modifing anything else.