[jmansracerocket]

well ive been tearing into the hammerhead again. Took the heat gun and finally pulled away the warn out ugly stickers on the flooring. Engine came out, Went threw entire engine cleaned and made my own gasket for the transmission and filled it up with oil. With the engine out of the way I did the ckau engine mount trick and have 2 bolts instead of 1 long one. Next I cut out the 2 bars that ran along the length of the rear swing arm as they where there for just mounting a piece of plastic under the sprocket. So cut those 2 bars out grinded down the welds nice and smooth. The 2 bars had the little square piece attached to them that I cut off them and made a bracket for speedo sensor for the trail tech . So freed up some space and weight and got a little bracket out of it is was a win win all around. All I did was stick the square metal piece on a vice heated it up and bent it to shape and then welded it on to the swing arm. Checked the trail tech and speedo works smoothly! Next u cut the electric box off the swing arm also. It was way to close to the engine for my liking, and u cant get the starter off because the metal sits to low! So same thing cut it off and grinded it down nice and smooth. I have the entire wiring harness out and just waiting for ckau to drive up ,to wire it up like he did on his yerf lol. I have 2 electric boxes one is a 8x8x4 and I bought a 4x4x4, seems like the 4x4x4 is to small and going to have to go with the 8x8x4 box just need to figure out where to mount it.