Thread
:
Side by Side Odyssey
View Single Post
#
16
01-27-2012, 02:23 PM
Rarerat
Contributor
Join Date: Dec 2009
Location: New Mexico
Posts: 456
Let the carnage begin!!
Just did a little mock up this morning with some scrap conduit I had to try and figure out how wide i want everything. As is i added 19"s to it but I am now thinking I my add another inch so I will have a little more room for the shifter between the seats. Sure I could move the seats out a bit but I want full protection for the driver & passenger in the event it ends up in it's lid. I will run into town next week and pick up some tubing so I can start the fab work. I am also thinking about adding 3 inches to the wheel base to make it a little easier to swap in a sled engine in the future.
Rarerat
View Public Profile
Send a private message to Rarerat
Find all posts by Rarerat