The fun never seems to stop.......
I'm taking this little hiccup as an opportunity to beef up my motor.
I bought and installed a NCY 2.2mm stroker crank along with the 1.6mm spacer that goes under the cylinder and an A-10 cam shaft.
I'm going to use my stock (home ported) head in the mean time while I get my perfromance head repaired or replaced.
As I attempted to install my cam, I found that my 90 link (stock) chain is too short. The cam won't even seat on the holder. If I were try and install the holder, something will break for sure.
So I added 2 links onto my chain, and now it's WAY too big.
I had to modify my chain tensioner by threading a small bolt (and reinforcing it) onto the bottom of the tensioner to take up the extra slack. Hopefully the chain guide can handle the extra bend in it now.
Not sure why this is???
NCY 2.2mm stroker crank
1.6mm spacer and 2 X .020 gaskets
NCY 58.5mm nikasil cylinder and piston
NCY .015 head gasket
Stock head (home ported)