Hmmmm....... Doesn't seem to have the Heavy Duty axle listed any more. I wonder what's up with that????
It's a joke how much I had to grind off of the axle to make the wheel hubs fit.
I then drilled and tapped the brake/sprocket hubs for set screws to hold them even and in place. You could hear "tink, tink, tink" as the axle spun and the brake rotor would move up and down on the splines.
I'm going to have to weld the wheel studs onto the wheel hub on one side since they were kind enough to not tap that hub for threads. Actually they drilled them for the wheel studs/bolts to fit through the hub. (too big to even tap them myself)
The icing on the cake for me is the writing in big letters on the wheel bearings CHINA.
What an extremely over priced piece of fecal matter!!!!!!
|