New to me (used) carb, same issue.
Installed the Mikuni VM 28 (flat slide even though it's designated as a VM) and am having the same issue.
Run the motor, shut it down, wait 2 mins and the fuel starts bubbling and pouring out of the overflow.
I'm going to install a new needle and seat, but doubt that will change anything. It didn't fix anything on the last carb. (VM 26-606)
On a good note, it seems to be running pretty good thus far.
NCY +2.2mm stroker crank
Breaking in the new rings (NCY 58.5mm)
NCY ported head with flat bottom SS valves (suppose to raise compression)
A 10 camshaft
Mikuni VM 28mm (flat slide carb) So far 15 pilot jet and 150 main 2 turns out on the idle mixture screw and top clip on the needle
Uni filter
TK exhaust
NCY CDI
Bando coil
Iridium spark oplug
14g rollers
16T engine sprocket (reverse)
36T axle sprocket
Last edited by xlint89; 12-09-2012 at 10:18 AM.
|