Motorin along ...
Installed the fuel tank, taillight and rad today, located the oil tank, needs 2 tabs. Getting into the controls now ...
Sunday's pics ...
I'm really liking the long tail layout. I may even have room for a little toolbag shelf behind the rad. Flipped the rad around and made it more vertical from what's shown in this pic.
Cut it really close with the output shaft hangar, gonna put in button heads. Shaft will get trimmed. 12.5 inches travel at full bump, presently uses 2.5 inches of shock travel with full tank, engine and fruit loop installed.
BTW, bolt-in cradle ... manna from heaven ... Did the engine and bearing hangar on the bench, dropped it on the jack and roller her in easier than my duck boots go on. Setting it up so that only cables, electrical plugs, and unfortunately, the oil tank lines need removed to pull the entire works off.