I strongly disagree about the copper cracking- It would survive very well under vibration. The bell fitting is the part I was talking about to put slits in-4 slits from the end to just before the bell tapers, take a strip of rubber slightly wider than the bell (an intertube works well), rap that around the outside of the carb inlet slide the bell end over the rubber (you could expand it alittle if needed) and close the gap on the slits with a hose clamp.To provide a support for the carb and air cleaner to could make a tab bracket the fits under the hose clamp and goes up to one of the many intake bolts. Or you can wait a month of Sundays!!!!!!!
|