Using the TAV 1 back plate the 7 inch is a no fit condition for belts.
You could slot the holes and move it out bit and use the 91 belt.
Or you could use the BMI Jack shaft for the yerf dog as I did.
you will need to build a mount to raise the secondary out of harms way...
I built that myself, but at this point I need to warn you its not a done deal and I am still having teething troubles.
With a 9 tooth primary drive and the stock 54 rear delivers around 40 MPH at 4500 rpm stock tyre ( give or take guess since I run a larger 20 )
The clutch and a strong motor can easily power threw the rear drum brake so you should consider upgrading the stopping power.
Hmm this is an old thread.....
I am new hear just reading and comenting incase this project has already been done.
|