View Single Post
  #74  
Old 09-19-2017, 05:40 AM
SYCARMS's Avatar
SYCARMS SYCARMS is offline
Supporting Vendor
 

Join Date: Sep 2009
Location: Senatobia, Mississippi
Posts: 3,375
Default

Unfortunately you need to pull the cylinder, piston and rings. Mic the cylinder it should be 72mm or 2.834". A couple thousands over is OK. I have known some people to over hone the cylinder way too much. Next put the top chrome ring in the cylinder first and using the piston square the ring in the cylinder. Remove the piston then measure the ring gap using feeler gauges. Gap should be .015-.016".
Reply With Quote