Thread
:
Everything crammed into one little mini buggy!
View Single Post
#
6
05-20-2012, 08:06 PM
n1kogr
Lite Contributor
Join Date: Oct 2011
Posts: 68
Got back on working on the buggy today and raised my roll bar. The front of it will be completely cut off and run straight to the yerf front end for upper support then a few support bars here and there.
Riped the cage off
Started raising it 4 inches. The rear is going to get lots of supports im not leaving it like that..
Its straight enough for me!
I also changed over to .35 wire on my little flux core and let me tell you my welds look better and are alot alot stronger
n1kogr
View Public Profile
Send a private message to n1kogr
Find all posts by n1kogr