Quote:
Originally Posted by BuggyMaster
For the exhaust, when I go to do this I plan on bringing it out along the side and then it will do a 90 degree at the rear of the swing arm and run paralell to the rear edge of the swingarm. Probably have to extend part of the pipe and have an exhaust shop do the bends so they are right. I figure just take the buggy to the shop so they can get it right.
|
you know i may do that.i wonder if it would change the power band of the motor by adding or taking away from the pipe becouse of the lacation of the expansion pipe.i can see that the size of the expansion doese this one is long and slinder unlike the ones on a bike (short and fat).bike motors are high rpm's and this one is for torke (4 wd) 5500RPM'S is about all this one doese.
35hp@5500rpms not bad thats more than hondas 400ex