Problem removing cvt cover due to frame clearance
Hey everyone, new to site and buggies, but I've plenty of small engine projects over years. I recently traded my jet ski for a 150cc buggy, it's a Dongfeng df200gka. It's set like most gy6 buggies, but when I went to remove the cover to put some new parts in, I can NOT get the cover off. There is a frame brace that runs diagonal from the top rear of the engine subframe to about midway on the cover. This frame pivots with the engine, and with the chain removed and engine up or down all the way, there's still no room. The clutch bell sticks out too close to the brace, almost like it was all assembled outside of the frame then installed. As far as I can tell, no other buggy has this brace or this problem. Am I correct or has anyone else had this issue, and a solution? Thanks in advance!
|