|
|
|
|||||||
| 250cc and Above Engine Tech Technical Discussion Forum for 250cc and up Engines |
|
|
Thread Tools |
|
#1
11-13-2010, 10:57 PM
|
|||
|
|||
150cc gy6 engine problems
I am working on a talon made by carter that has this 150cc gy6 engine.first i discovered that the start clutch was bad and also sheared the woodruff key so replaced and tryed to start but acts like timing is off. Any suggestions?
Thanks tracy |
|
#2
11-17-2010, 01:57 AM
|
||||
|
||||
|
Pull the spark plug out and get a straw to stick down in the cylinder and roll the motor to Top dead center, then pull the valve cover off and on the cam gear there will be 2 small holes that should be parallel to the valve cover mating surface and a big hole that should be pointing at the seat.
__________________
09 Joyner Sand Viper 250 08 Joyner Sand Viper 250 2009 Joylaris 400 Screamer http://www.youtube.com/watch?v=eeulR4W1_PU |
|
|
