|
150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
Thread Tools |
#1
|
|||
|
|||
High Performance CDI for gy6 clone help!!
Hello everyone! I am new to the forum so I hope I am doing this right..... I just got a 2010 spider 150cc built by Kandi. Its a lot of fun! I have already gutted exhaust, put a tach/hour meter for maitnence/tuning info,got a uni filter on, and put a high performance coil on. My next steps are CDI, carb rejet, 10g-12g rollers, and a 1500 RPM Spring. I have two questions... 1. I went to our local store here thats sells gy6 parts looking for a perfomance CDI and he said mine looked like one out of a 250cc because of how big it is. It is a 6 wire with two square connectors. He also said he knows of no performance CDI's that will fit my buggy. Is he right or just misinformed? 2. I live in Logan,Utah with an elevation of 4,775 Ft. Knowing that does anyone have a good starting point for me with rejetting the carb?
|
#2
|
||||
|
||||
welcome to the group-i run a 125 jet when i run my stock carb at 5500 & up-i would start at 120 and go from there-almost all carbs will vary on final jet i keep from 115 thru 135 jets on hand-post pics of your cdi connectors might help
__________________
olderthan 2008 tomberline punisher 1500 spring 12g sliders 30mm cv pumper carb uni filter no rev cdi polaris xlt snowmobile shocks for front w/550 magnum springs & blaster fronts on rear and another buggy built working on mods gk-13 white spring 17 gram sliders so far |
#3
|
|||
|
|||
Here are the pics of my stock CDI
The square plug has only three-wires going to it and the rectangle plug only has one wire going to it.
|
#4
|
|||
|
|||
check scrappydog in las vegs i found one there i believe i have one that will work orderd for mine then swapped to a hf engine instead
|
|
|