|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
|
Thread Tools |
|
#1
05-13-2011, 02:53 PM
|
|||
|
|||
Gear case oil change 150cc
Not sure how to tell which bolt is the oil fill bolt for a 150cc Chinese go cart. I've already drained the gear oil but not sure where the oil fill bolt is. Any help would be appreciated as the owners manual is completely worthless.
|
|
#2
05-13-2011, 05:31 PM
|
||||
|
||||
|
There should be 2 larger bolts than the others that face the rear of the case.Lower one to drain upper to fill. Usually need a small tube attached to a funnel or tapered gear oil bottle.
|
|
#3
05-14-2011, 02:49 AM
|
||||
|
||||
|
At the very rear of the CVT cover on the side of case will be the fill plug. It will be the only 10mm bolt. If you go to WalMart they sell a syringe used for mixing oil in fuel for the 2 stroke engine which is locared in area of 2 cycle oil. This is what i use to fill the final drive. Service it just like a car rear end. Fill on level ground until the lube is level with fill hole threads.
TOM |
|
|
