|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
|
Thread Tools |
|
#1
01-09-2012, 09:33 PM
|
||||
|
||||
Will this reverse fit?
http://cgi.ebay.com/ws/eBayISAPI.dll...m=120801249255 Found on ebay. will it work with a short case? What else would I need?
__________________
If the only tool you have is a hammer, Then all your problems look like nails. Last edited by Lyonsperf; 01-09-2012 at 09:35 PM. Reason: pic |
|
#2
01-10-2012, 07:42 AM
|
||||
|
||||
|
It looks like it will fit, but i don't know if you'll need a different shaft on the gy6. do you have a pic of yours? It'll need to have the splines on the outside and the correct shaft length with locking nut threads on the end. I have an engine with the reverse off it at the moment, so i can put up the dimensions if you need them. Other than the trans, you'd just need cable, shift lever and a stabilizing bracket that goes from the two bolts on the reverse assy to the cylinder case of the engine.
|
|
#4
01-10-2012, 10:46 AM
|
||||
|
||||
|
you're going to need a different one. There are about 3-5 different ones on e-bay, i'm not sure which one it is, i'll get the "outside" portion of the shaft measurements for you. 25-40 bucks looks to be the price range.
|
|
#5
01-10-2012, 03:32 PM
|
||||
|
||||
|
Contacted that seller and he didn't know anything about the particular unit. ):
So i'm a bit leary of buying it from him.
__________________
If the only tool you have is a hammer, Then all your problems look like nails. |
|
#6
01-11-2012, 11:00 AM
|
||||
|
||||
|
that reverse looks pretty much identical to what's out there with the exception of the cable housing--that looks a lot cheaper. For the price, i don't think it would be a bad deal. It looks like someone checked out the pricing of the units and found a china shop to pump them out cheap enough to undercut the market.
|
|
|
