|
|
|
|||||||
| Electrical Tech General Tech for Electrical issues not related to specific engines (Lights etc) |
|
|
Thread Tools |
|
#1
01-17-2012, 05:09 PM
|
||||
|
||||
CDI upgrade no spark
I have 2 crossfire 150 non r
GY6 motors LH157QMJ motors I bought Performance CDI,s I bought them from ********** online The dont seem to work ! NO spark ! Should be plug and play. Stator is stock not sure how many poles never open it up. My stock CDI is prong 3 nule so i know i dont have a dc CDI . Any Idea,s on what i can do ? or were to look? Last edited by drillpvt; 01-17-2012 at 06:15 PM. |
|
#2
01-18-2012, 12:16 PM
|
||||
|
||||
Hmmm..you sure the replacements were DC based?
Personally, I don't put all my money in CDI's. They are most beneficial with mods that require it. |
|
#3
01-19-2012, 05:20 PM
|
||||
|
||||
|
the dc units look just like ac unit, on your cdi there is a 2 wire plug, if there are two wires going into that plug you have a ac fired system. also check to see if there is a signal ( very low voltage ) coming from the pick up coil wire, most are blue with a white stripe
|
|
#4
01-19-2012, 05:26 PM
|
||||
|
||||
|
My Gy6 is a AC system and the Perforance cdi,s i bought are AC , but no spark once plug in , so im not sure what the issue is . Hate to think i bought them and cant use them , is the stock staor enough ?
|
|
#6
01-19-2012, 07:38 PM
|
||||
|
||||
|
the stock stator wil be fine. coming from the stator side of the case are some wires, look and see if one is blue with a white stripe, that one goes to the cdi. check to see if their is a low voltage signal coming from it
|
|
|
