BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum

Go Back   BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum > Technical Discussions > Go Kart Engine and Torque Converter Tech

Go Kart Engine and Torque Converter Tech Forum for discussing go kart engines and torque converters (Briggs, Tecumseh, Suburu, Comet etc)

 
 
Thread Tools
  #1  
Old 02-12-2012, 11:50 AM
drillpvt's Avatar
drillpvt drillpvt is offline
Contributor
 

Join Date: Jan 2012
Location: Punta Gorda FL
Posts: 183
Default GO-cart

I have a old school go-cart frame in the workshop i want to put togeather.
I have a 10hp Briggs motor that was taken out of a genarator. The shaft coming out of the motor is a 7/8 in dia . Smooth no key.
I woyld like to go clutch to sporket . Anyone know were to buy what i need not haveing a key in the shaft ?


  #2  
Old 02-12-2012, 12:26 PM
x-bird's Avatar
x-bird x-bird is offline
Power User
 

Join Date: Oct 2011
Location: Penciltucky
Posts: 2,518
Default

the taper is what was used, for your purposes, there aren't many options.

Pull the crank and have a keyway machined into it.
Swap the crank for one with a keyway in it.

Go shadetree ...
Weld a tall bead run into it and cut/grind it back to keystock dimensions.
Drill some deep "dimples" into it and red loctite the screws on a centrifugal clutch with at least 2 set screws.
  #3  
Old 02-12-2012, 12:28 PM
drillpvt's Avatar
drillpvt drillpvt is offline
Contributor
 

Join Date: Jan 2012
Location: Punta Gorda FL
Posts: 183
Default

end it threaded so i was not sure if thier was a bolt on clutch out thier , I can break into her but not sure if this 3600 rpm motor is worth it on the cart in the long run !
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:31 AM.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.