|
|
|
|||||||
| FrankenBuggy Tech Unconventional and Home Built Buggy Tech Forum |
|
|
Thread Tools |
|
#1
02-19-2012, 07:49 PM
|
|||
|
|||
Fresh From The Paint Booth
Hi all,
Chassis is freshly out of the paint booth as of 4:00pm today. My dad is a custom painter and helped me out to save some time. The a arms and rear swing arm will be shot in black to give the buggy some contrast with the diamond plate flooring and the black rci seats and blue seatbelts. Last edited by robertnoble; 03-17-2012 at 04:31 PM. Reason: Fresh From The Paint Booth |
|
#2
02-19-2012, 08:05 PM
|
||||
|
||||
|
Why did you open a new thread for your project?!!!! Look'n good
|
|
#5
02-22-2012, 12:26 AM
|
|||
|
|||
|
It depends. Right now I have a brand new crated 16hp with a trailboss transmission that has all been rebuilt and shafts turned down for a comet series 40. I didn't plan on getting this involved with the project, although It is super light the way it sets right now it weighs only 175lbs, but the motor transmission, aluminum flooring , fuel tank etc. isn't in it either, so should weigh about 290 lbs when done. It is all dom nhra approved 1 inch o95 wall tubing. Anyways if I could get rid of my new clutch, motor and transmission I want to upgrade to a 4 stroke liquid cooled snowmobile engine. But if not I will run the setup that I have. With the gears that I am running, first gear is a 4.30 gear ratio which puts the roll out at a 51 mph speed. So time will tell, If I can sell it soon, thats the plan. Thanks for looking... Robert
|
|
#6
02-22-2012, 03:38 AM
|
||||
|
||||
|
Man that thing will be light, what kind of punishment will you be putting it through? will it hold up?
__________________
T.J. Yerfdog Spiderbox, Uni Type air filter with 6" intake, 130 jet, Orange no-rev limit cdi, Red coil, iridium plug, 1500rpm clutch springs, 1500rpm contra spring, 13g sliders, 22" rears, 21" fronts, aftermarket reverse installed, and Trailtech Vapor. |
|
#7
02-22-2012, 10:55 AM
|
|||
|
|||
|
Well yea, the tubing is the same tubing that USAC Midget spring cars build there cages with. It is well designed with all great parts. Fox Fully adjustable 16" shocks, MPC Disc Brakes, Douglas Racing Wheels, raptor rack and pinion, and everything else is put together as good as one can be put together. Thanks for looking Robert
|
|
|
