I Need...

[ckau]

Two axle hangers off a yerfdog 3206 rear swing arm assembly. I don't need the whole swing arm just the axle hangers. Perhaps there is someone who has a un-usable swing arm they could hack out the sections the hangers are welded to?

[x-bird]

would a pair off a 3203 work?

[xlint89]

Can you make these work?

http://www.*************/item/Bearing...or-400175-1224

http://www.*************/item/2-Hole-...er-400171-3202

[ckau]

Originally Posted by x-bird

would a pair off a 3203 work?

don't know.. can you post the dimensions? length and width of the plate? The hangers need to be the size as the originals I use them for the outer bearing supports on the 3206 swingarm.
The BMI hangers are too small.

[metalstudman1]

I have a set on an old swingarm- I'll hack them off tomorrow night for you.

[x-bird]

3/16th plate
4.75 wide
6.25 tall, minus 1-1/8" for the "easy" chop
bearing hole 2.25 dia.

some 1/4 plate and a hole saw might be easier/cheaper than the shipping?