|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
|
Thread Tools |
|
#1
03-25-2012, 11:41 AM
|
||||
|
||||
11 Pole Stator Wiring
My neighbor gave me an 11 pole stator from a gy6 his son was working on but lost interest. It has one plug with four wires colored Pink,Yellow,White and Green. It then has two free wires, 1 Blue and one Black with red.
He also gave me the matching rectifier that has two plugs. One plug has three yellow wires and the other has one pink and one green. The plugs on these parts do not match so my question is what wires connect to what? I know the blue wire is the pickup to cdi and the black with red is the cdi power. But how does the pink,yellow,white and green connect with the three yellows, pink and green of the rectifier?
__________________
If the only tool you have is a hammer, Then all your problems look like nails. |
|
#2
03-25-2012, 12:22 PM
|
||||
|
||||
|
Can you take a pic of the stator?-usually you can trace the wires back to the windings to figure it out.
|
|
#3
03-25-2012, 02:47 PM
|
||||
|
||||
|
stator.jpg
This is a pic of the stator I have. The actual one is already installed with the flywheel. This is the rectifier.gy6statorregulatorrectifier.jpg
__________________
If the only tool you have is a hammer, Then all your problems look like nails. |
|
#5
03-26-2012, 08:41 PM
|
||||
|
||||
|
OK got it figured out.
For future reference the 11 pole stator can have 3 yellows and a green or 1 pink, 1,yellow, 1 white and 1 green. The green is the ground on both. You should connect the other three to the 3 yellows coming from the rectifier. The rectifier wires go: pink goes to battery + and the green goes to ground.
__________________
If the only tool you have is a hammer, Then all your problems look like nails. |
|
|
