Let your ideas flow forth like oil from a busted crankcase.
I got this four wheeler frame for $20, and this Troybilt tiller for nothing. The tiller aparatus is shot but the engine is stroooooooooong and has had all of maybe three hours run on it before the owner let everything but the engine rot by planting a 30 gallon wash tub over the engine.
My intentions are to cut the frame in half and use an old trailer axle to extend it about three feet. The axle will be cut in half and will be more than strong enough to make the extension. I will shave and brace all bars with what I need. I intend on welding a motor base and mount just to the rear of the rear wheels where all I have to do is align and mount the engine and install a chain to the proper clutch. The engine is has a vertical shaft but it was apparently designed to run on its side as you can see from the top of the engine facing forward and I would only have to align and install chain.I have never done this before so it will be challenging but I am sure I can do it.
When the frame is extended I want to install a seat from a yerf dog or even find one that will be more reclined and put nerf bars around the cock pit with roll bars. I am going to use an aluminum truck bed extender for the nerfs so that I can shave weight. I believe I will just heat and bend the steering column towards the cockpit and just use handlebars instead of a steering wheel as to have the throttle just like an atv.
Please help me out with any and all ideas that you may have. I will keep you all posted with pics and progress. I know that you all have a plethora of experience with trial and error so if you see something coming at me I would greatly appreciate any forwarning as to save me as much money as possible. I would love to see any design tips you guys have and if you have anyone who has tried anything like this before, I would appreciate a link. Thanks in advance for your help. And I look forward to seeing your ideas.
|
04-23-2012, 11:58 PM
