|
|
|
|||||||
| Other tech issues For all other technical issues. Think frame, suspension, steering, brakes, etc |
|
|
Thread Tools |
|
#1
05-21-2012, 04:26 PM
|
||||
|
||||
Front/Rear susp. homebuilt/mod ideas
Through all of the work on the buggy, i've come across a lot of different approaches for front and rear suspension components using pre-existing items.
here's a few from the golf cart "line-up" Up front: This particular model golf cart differs from most in that it has a solid beam connection up front that could be cut, boxed and heimed for an instant spindle/hub assembly. http://www.ebay.com/itm/Used-front-a...item1c22683bce This one could be a near weld-in deal, and could be split and modified to work as an IRS as well .... http://www.ebay.com/itm/Chrysler-GEM...item56445901bf For those wondering, this is the most common front cart suspension, unsuitable for rough terrain because of roll-under deflection of the transverse leaf spring and limited travel. could be adapted to work for a smooth dirt-tracker or mini sand rail. Used in most club car, Ez-Go etc electric and gas carts. http://www.ebay.com/itm/Club-Car-Hub...item4cf32ae09e However, the hubs are excellent, they are 4x4 bolt pattern on a 1" axle. Bearings are tapered type like most non-strut cars/trucks and very heavy duty. They're what i have in the Rockhound. Hub/spindle alone is below. A "V" cut through the spindle to free the axle allows it's curved surface to be saved and reused on another spindle tube (1 1/8th cro-moly in my instance). The hits this combo has survived without any damaged has surprised me. Also made me confident in my welds' integrity. http://www.ebay.com/itm/Ez-Go-Golf-C...item2a1b41a8bd At the rear: presently considering a set of these as hubs ... http://www.ebay.com/itm/YAMAHA-GOLF-...item519e42ce71 With a pair of these mated together somehow for an axle. http://www.ebay.com/itm/EZ-Go-golf-c...item5ae511182c Before going this route i have to find out shaft dimensions, steel spec etc on them and talk to an old racing buddy in Reading who runs a driveshaft and axle shop to see if can come up with an insert bearing carrier tube that would double as the brake/sprocket hub for me. Just some fodder for the mill of minds around here 
|
|
#2
05-22-2012, 08:44 PM
|
||||
|
||||
|
The 3rd front end with the leafspring would be an easy conversion to dual A-arms -change the leafspring to an A-arm. I like the splined hubs- having many splined axles & hubs here, it's hard to know what will work together though. I have a couple of items that have 19 splines and won't interchange because the diameter is slightly different. I'm assuming there's not a common set of splines from one manufacturer to another.
Last edited by metalstudman1; 05-22-2012 at 10:07 PM. |
|
#3
05-22-2012, 11:27 PM
|
||||
|
||||
|
probably not, i'm asking around buggiesgonewild at the moment (golf cart mod site) as to the spline count and dia. on the yamaha hubs. can't find specs on them. I want to stay away from a keyed axle/hub at the rear. Been meaning to give a call to the guy that did my spindle pins to see what it would take to match up a set on raw stock. that way i could put bearing stops etc where i want them.
|
|
|
