|
|
|
|||||||
| Other tech issues For all other technical issues. Think frame, suspension, steering, brakes, etc |
|
|
Thread Tools |
|
#1
08-29-2012, 10:42 PM
|
|||
|
|||
Clutch slipping - Rocketta 50cc
Hey guys. New here, I've got what I believe is a 50 cc Rocketa, 3 speed - POC from China that my kids have out grown. It ran like a bat outta hades until the frame broke at the weld on the rear. Well my buddy fixed it good as new and I reassembled the rear end remounted the motor and now the dang clutch is slipping. I don't know how to adjust it. I've included a picture from Christmas Day.
Just to further clarify: It's a 3 speed 50 cc motor cycle engine clone. Is this a simple fix or what? I don't recall any lateral adjustment. Chain tension is good. I need to find a new owner for this thing so I'd like to have it running. All help greatly appreciated. WP |
|
#2
08-30-2012, 06:49 PM
|
||||
|
||||
|
Welcome- I don't know it yours has the same type of engine as my 110cc. On the passenger side of the case was a jam nut with a slotted screw in it that allows for clutch adjustments.
|
|
#3
09-01-2012, 07:05 PM
|
|||
|
|||
|
question
I think I found the slotted screw on the passenger side. Pic #1 is that side #2 the driver side with the linkage shown.
My question is: If it slipping do I tighten to the right after loosening the nut? My brother lives in Belmont BTW. Thanks for your help. WP |
|
#4
09-01-2012, 08:13 PM
|
||||
|
||||
|
I can't remember the direction-- Mark the position of the slot before adjustments so if you go the wrong way like I did you'll know where you started. I do remember it didn't take much of an adjustment to get it grabbing again.
|
|
#5
09-01-2012, 11:17 PM
|
|||
|
|||
|
http://www.youtube.com/watch?v=1pP_L85mo7A same concept.. I hope this helps
|
|
|
