#1
|
||||
|
||||
Wiring CDI
I got the schematic for the 6 pin cdi a/c. I routed all the wires except the pin that handles the kill switch. Does this pin receive 12 volt power through a switch? Or does it act as a ground with the switch opening and closing the ground circuit? I got a switch panel with ignition on/off, momentary start and lights. Would I route the kill pinout to one side of the ignition switch and the other side to 12v+?
__________________
If the only tool you have is a hammer, Then all your problems look like nails. |
|
|