|
150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
Thread Tools |
#1
|
|||
|
|||
problems on yerfdog rover
I recently i bought a yerf dog Rover cuv it has a new carb and new starter if you use the choke it won't start but without choke it will... it idles up and revs up fine in neutral but while driving it bogs down and when climbing a hill bogs down bad and doesn't hit full speed on a flat surface Climbing a hill last night it flooded out and gas went Back to the filter the only way it would run was to remove the filter housing assembly any answers or questions would be appreciated
Last edited by Rover; 11-26-2012 at 08:23 AM. |
#2
|
||||
|
||||
1 step at a time
Welcome 2 the forum! I'd start with a good carb cleaning & inspection, & go from there.
|
#3
|
||||
|
||||
P.S. check ur fuel feed 2 the carb too!
|
#4
|
|||
|
|||
Carb and lines clean tank is clean also has stabilizer in tank do you think that the filter so stopped up it's acting like a choke
|
#5
|
|||
|
|||
fixed
The float alighnment pin was wedged sideways holding the float valve wide open also a new air filter was added gained speed and engine runs great paper filter is next to go UPGRADE TIME....
|
#6
|
||||
|
||||
Yeah boy the fun begins!
|
|
|