|
150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
Thread Tools |
#1
|
|||
|
|||
Ideas on how to make this part?
The attached picture is the part I need to make. It's the hose that goes from the air cleaner to the carb on a carbide 7150 GY6. Can't find it for sale. Anybody made one in the past? Ours has ripped. Thanks
|
#2
|
||||
|
||||
Have you thought about using the UNI filter and losing the stocker?
|
#3
|
|||
|
|||
No what would the cost be on that?
|
#4
|
||||
|
||||
Not too much. I bought a spectre reusable filter with adjustable outlet from advance auto for $20. Use the 4 inch size of it. Go to a plumbing supply store and get a 3 inch to 2 inch reduced which is around $8 and a 1.5 inch to 1.5 inch rubber coupling about $5.
__________________
You Can't Fix Stupid It Is What It is A Country Boy Can Survive |
#5
|
||||
|
||||
I don't know specifically on your model, but most of them just consist of a rubber coupling, a small piece of pipe (usually from the plumbing dept at Home Depot) and the UNI filter. Also known as the "redneck intake".
Pipe cost is around $5 and the UNI filter is around $20ish. Many guys like Rebel have done similar stuff like this. Do a search for "redneck instake" and see what you can find. |
#6
|
|||
|
|||
Thanks I'll check it out.
|
#7
|
||||
|
||||
Ya other than the filter itself you can get the parts at Home Depot. I thought there was a thread on this from a long time ago in the tech section.
|
|
|