|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
|
Thread Tools |
|
#1
01-04-2014, 05:37 PM
|
|||
|
|||
GY6 Carb setting
What is the 150cc GY6 normal carb setting
|
|
#2
01-04-2014, 08:20 PM
|
|||
|
|||
|
What do you want to know? Jet sizes? Fuel mixture screw? Float height?
|
|
#3
01-04-2014, 08:47 PM
|
|||
|
|||
|
it's a stock carb and just need to know the setting on the lower driver side screw setting not the idle screw
|
|
#4
01-04-2014, 08:57 PM
|
|||
|
|||
|
I think the stock setting is about 2-1/4 turns out from lightly seated, but you should set it at the point the engine likes (in or out from 2-1/4 to get the highest rpm). The float height should be the first thing you check though. Stock height is 18-19mm.
I just checked my original carburetor specs. Stock settings on 2012 Trailmaster 150xrs: air/fuel screw 1-1/4 turns out (The manual says to turn the screw in gently until it stops, then back it out 2-3/8 turns. Then turn it in counter clockwise to achieve the highest rpm. Idle rpm =1400). Pilot jet =35. Main jet =111. Float height =18mm. Like stated on the other forum, check the auto choke for proper operation. Last edited by 351mustanger; 01-04-2014 at 09:50 PM. |
|
|
