powering accessories
Hi Folks,
I'm about to start my custom dash project on my trailmaster 150, and I need some advice. Where is the best place to grab some key-on voltage to power things? I've bought a bunch of electrical quick connectors that match the ones used on my buggy and was going to attache additional wires to the one of the leads under the existing dash and re-crimp the connector. Basically I have an aluminum instrument/gauge housing that I'm replacing the dash on my trailmaster with. I'll be transferring my ignition, headlight switch, and engine kill switch into the new dash as well as installing a voltmeter into it. Also, I'll be attaching a trailtech Vapor onto the top of the housing and powering it from one of the additional leads. I figure someone here has done it before..
__________________
2013 Trailmaster XRX 150 Type 86 stroker
Taida 4V head with 23/22mm valves, forged 4V piston,Taida 62mm jug,forged Taida 8200 KDU stroker crank, Koso high-flow oil pump, Taida case half w/ oil cooler ports, Setrab oil cooler,TrailTec Vapor, Mikuni VM26-606, aluminum 30mm intake, Uni filter, aluminum stack, Hammerhead racing exhaust, MotoRio adjustable CDI/HO Coil, Iridium plug, Full Dr Pulley CVT kit w/ 16g sliders, JD's Mikuni slide kit
2014 Kandi 90B
|
03-18-2014, 12:20 PM
