Needing info on a 60mm crankshaft

[RedBarron989]

I would like to get a stroker crank for my 155cc but it says my crankcase will need to be machined for it to fit. I measured my stock crankshaft looking for the 58.mm piece and i just wanted to see how big of a difference it would be but i couldn't find anything. At first i thought it would be the piston rod, i measured the piston rod from the top of the crankshaft to right under the loop on the piston rod and it was really close but then i saw the crankcase had to be machined. On this crank what is bigger on it, also any good or bad news about this product will help me out. Thanks

[x-bird]

Tom/SYC is your best source for info on doing a stroker and the pros and cons.

[bear]

I've heard alot of praise about Tom's bbk skills for sure!

[RedBarron989]

found the site, thank you all

[SYCARMS]

What buggy do you have?

[x-bird]

Elvis hasn't left the building! Been a little busy lately Tom? Got worried since i haven't seen you post in awhile. )))

[SYCARMS]

Been playing catchup lately. Had to go to Chicago for Brothers Funeral and to tie up some loose ends with his estate then this past weekend I had a ride in Missouri which was my Birthday gift to myself. With the computer problems , DSL problems and work comming in by the time I get in at night prepare dinner I'm out for the night. I need to show more presents on here but as of late it has been a challenge. Oh and probably the worst nightmare, shopping for health insurance since my current plan dropped me the last minute due to the new law. So Elvis has not left the building, the shades are drawn and the lights have been off is all. lol