|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
|
Thread Tools |
|
#2
07-03-2014, 09:52 AM
|
|||
|
|||
double check the electrical and vacuum connections. You say you put some miles on it.. Did it get soaked? hard bump? Anything that might have upset it?
__________________
2013 Trailmaster XRX 150 Type 86 stroker Taida 4V head with 23/22mm valves, forged 4V piston,Taida 62mm jug,forged Taida 8200 KDU stroker crank, Koso high-flow oil pump, Taida case half w/ oil cooler ports, Setrab oil cooler,TrailTec Vapor, Mikuni VM26-606, aluminum 30mm intake, Uni filter, aluminum stack, Hammerhead racing exhaust, MotoRio adjustable CDI/HO Coil, Iridium plug, Full Dr Pulley CVT kit w/ 16g sliders, JD's Mikuni slide kit 2014 Kandi 90B |
|
#3
07-04-2014, 06:25 PM
|
|||
|
|||
|
Check the air filter. I have seen them get oil soaked. The valve cover breather tube runs into the air box and can blow engine oil on the air filter. When the paper filter gets oil soaked it will not draw enough air.
You can check to see if it needs gas by removing the spark plug and adding a 1/4 oz. of gas to the cylinder. Be careful when tightening the spark plug back up. The threads can be easily stripped. Last edited by 351mustanger; 07-04-2014 at 06:30 PM. |
|
|
