|
|
|
|||||||
| Electrical Tech General Tech for Electrical issues not related to specific engines (Lights etc) |
|
|
Thread Tools |
|
#1
08-02-2015, 08:07 PM
|
||||
|
||||
Making new hammerhead harness
ok any one good with electrical work please chime in. I posted under ckau's thread also but I figure while I wait for his response make a thread under electrical. Researching and trying to figure out how im going to finish building the hammerhead wiring harness I was going to go either 6 position or 8 position power fuse.
http://www.delcity.net/store/ATC-&-A...ng-Pad/p_11262 and then I would get 15 amp fuses http://www.delcity.net/store/ATO®-S...Fuses/p_800317 heres some pics of my wiring harness the stock wiring is just a mess once balled up in the little box. plan is to clean it up so everything has its own power and ground. This is also going to be nice because with the the power position strip I can wire the trail tech for straight power and power the wideband. Im trying to figure out if I do this also can I delete the relay that the stock harness has.    I should have the engine mounted in tomorrow that way I can see where I want to mount the box and how I want to run the wires.
__________________
Hammer head Single seater know as herbie under construction Aluminum fuel tank, aluminum wheels, custom fuel/cargo rack, entire rewire, trail tech vapor, ported big valve head, a12camshaft, 12 gram sliders, straight intake, kirkey wide seat, front end extension. 4 point harness, welded cage. Hammerhead exhaust. Blade Single Seater Restore welded cage, engine build, new wiring harness/electric box, spun aluminum fuel tank. |
|
#2
08-03-2015, 09:29 AM
|
|||
|
|||
|
I posted a reply in the other thread too. I would suggest getting a few extra circuits more than you need just incase you want to add something in the future your fuse block will be ready for it. Like some more lights, a 12 volt outlet, a winch or something.
|
|
#3
08-03-2015, 11:59 AM
|
||||
|
||||
|
Quote:
 , with 10 15 amp fuses, from what I am counting il need 7 power spots, so il have 1 extra spot if I ever need it. I did try calling the company I ordered it from I should have just ordered the 10 gang but they said it already shipped out so no biggy.
__________________
Hammer head Single seater know as herbie under construction Aluminum fuel tank, aluminum wheels, custom fuel/cargo rack, entire rewire, trail tech vapor, ported big valve head, a12camshaft, 12 gram sliders, straight intake, kirkey wide seat, front end extension. 4 point harness, welded cage. Hammerhead exhaust. Blade Single Seater Restore welded cage, engine build, new wiring harness/electric box, spun aluminum fuel tank. Last edited by jmansracerocket; 08-03-2015 at 02:04 PM. |
|
|
